Requirements and acceptance for cable and wire harness assemblies

Gaining comprehensive knowledge necessary for wires and wire harnesses assembly according to IPC/WHMA-A-620 standard.

Chapter I – Introduction: generally used procedures and information about program, most important definitions.
Chapter II – Documents used in IPC/WHMA-A-620 standard.
Chapter III – Wires preparation.
Chapter IV – Solder ends.
Chapter V – Formed ends.
Chapter VI – Connection of isolated wires preventing from its displacement.
Chapter VII – Ultrasonic welding.
Chapter VIII – Braided connections.
Chapter IX – Connections of wire shields and protection sleeves.
Chapter X – Shaping/filling.
Chapter XI – Cable and wire connections.
Chapter XII – Marking/labelling.
Chapter XIII – Coaxial and twinaxial cable connections.
Chapter XIV – Wire harnesses protections.
Chapter XV – Electrical covering/shielding of wire and cable harnesses.
Chapter XVI – Protective layer for wire and cable harnesses.
Chapter XVII – Mechanical installation.
Chapter XVIII – Wire installation by coiling without soldering.
Chapters I and II are obligatory, the rest depending on customers requirements

Directly involved in mounting and control of connections using wires and cables.

Gaining the newest knowledge about wires and cables assembly requirements according to current international standards.
Getting textbooks with didactic materials.
Receiving personal, international certificate of finishing IPC/WHMA-A-620 Certified IPC Specialist training.